How To Change Turn Signal Switch On 1995 Olds Cutlass Supreme

How to Repair an Oldsmobile Cutlass Turn Signal Switch

by Gregory Crews

Darren McCollester/Getty Images News/Getty Images

The turn signal switch in an Oldsmobile is integrated with a multi-function switch that is responsible for operating your windshield wipers, cruise control, lite dimmers and your plow signal. When one component on this switch fails it is fourth dimension to replace the whole unit. Replacing the unit will not take very much fourth dimension.

Removing the Turn Indicate Switch

Footstep 1

Open up the hood for admission to the battery. Disconnect the battery'south positive and negative terminals.

Footstep 2

Remove the steering wheel shroud assembly. This is the plastic wrapped around the steering cavalcade. The housing is held by Phillips head screws.

Step 3

Twist the turn signal lever frontwards and pull it out. Put it in a safety identify for subsequently installation.

Pace 4

Disconnect the wiring harness from the back of the switch. The wires can exist removed by pulling the tabs on the side of the connector and pulling until they're free from the switch.

Unscrew the ii screws belongings the switch in place. The multi-switch is ready to exist removed.

Installing the Plow Signal Switch

Stride 1

Screw the new switch to the steering column with a Phillips head screwdriver. Ensure the switch is tight against the column.

Step two

Plug the wiring harness into the switch. Button the connector in until it clicks in place.

Stride 3

Attach the lever to the switch. Push the lever into the switch and twist toward the forepart of the vehicle.

Pace 4

Cap the steering column with the shroud covers. Spiral the shroud dorsum together with a Phillips head screwdriver.

Reconnect the battery by installing the bombardment terminals. Examination the multi-switch by checking each function to ensure it is installed correctly.

References

• Haynes Repair Manual for Buick,Pontiac and Oldsmobile;1985 to 2005

Tips

• The type of screws property the shroud together may vary but the process is notwithstanding the same.

Things Yous'll Need

• Phillips head screwdriver
• New multi-switch

Warnings

• Use extreme circumspection when working with the electrical system. Ensure the battery is isolated to preclude electrical stupor.

Writer Bio

Gregory Crews has been in the film industry for iii years and has appeared in more than 38 major motion pictures and 16 idiot box shows. He as well writes detailed automotive tutorials. His expertise in the automotive industry has given him the skills to write detailed technical instructional articles.

More Manufactures

Source: https://itstillruns.com/repair-cutlass-turn-signal-switch-5779794.html

Posted by: ballardloffinds.blogspot.com

Share this post